Hello,

I tried to get the DA14531 module in hibernation with the da14531_configuring_da14531_hibernation_mode example code. This example was not working properly, because I measured a current consumption of 10uA, both on the power profiler and a multimeter. After trying to flash a different example, I couldn't get the module to connect on the pro devkit. I've had similar problems before, but when I flashed the module via UART it worked fine again. Now, the module isn't responding to SWD, 1-wire UART, 2-wire UART, and SPI.

Is there a way to recover the module from its hibernation?

Thanks,
Martin