雷竞技电竞平台对话框半导体客户支持- BLE_WAKEUP_LP_Handler https://support.dialog-semiconductor.com/resource-keywords/blewakeuplphandler en DSPS project and periph_init https://support.dialog-semiconductor.com/forums/post/dialog-smartbond-bluetooth-low-energy-%E2%80%93-software/dsps-project-and-periphinit
Forums: 
Dialog Smartbond Bluetooth Low Energy – Software

Hello
I'm trying to use DSPS project(DSPS 5.150.2). I added one characteristic to control GPIO at DSPS original project.
I can check the gpio is changed when I change the value of the characteristic.
The problem is that 'BLE_WAKEUP_LP_Handler' is continuously called which is calling the 'periph_init' function so that the gpio's state goes back to default state right after changing by BLE.
Could give me some advice about this?

Keywords: 
DSPS
GPIO
periph_init
BLE_WAKEUP_LP_Handler
Device: 
DA14580
 Fri, 24 Aug 2018 07:13:26 +0000 Daekeun Yun 222295 at https://support.dialog-semiconductor.com https://support.dialog-semiconductor.com/forums/post/dialog-smartbond-bluetooth-low-energy-%E2%80%93-software/dsps-project-and-periphinit#comments