Hello Dialog_Support,
I am using beacon mode to broadcast advertising data string. If i want to send some dynamic data then i changed the manufacturer data string and broadcast. At the mobile application side they are receiving advertising data but not getting the byte i have changed. BLE Scanner is able to receive data in form of raw data.
Mobile App is receiving 0 at data field so can you tell me where is the data field located in advertising data? Can you suggest any App other then ble scanner which can able to receive advertising data string?
Thanks and Regards,
Ruchi Patel
Good Afternoon,
I have purchased a PAN1740 evaluation kit from the board. I would like to customize the beacon's identifier strings (they are currently set as per the value indicated in UM-B-019).
How can I go about doing this? I have found reference to using the Smart Tag (proximity) samples from the SDK, but the software did not want to boot after programming (at least I could not see anything in the Locate application).
Thank you in advance for an indication of where I might be able to look for more information.
Best regards,
Mathew
Hi all,
I've demodulated an advertisement frame from a DA14580 device using the rohde and schwarz CBT BLE tester. However, I'm having trouble understanding the frame structure. I've attached a picture (in pdf) showing part of the demodulated frame.
Why are there extra bits before the 1 byte preamble?
Is a carrier tone (indicated by arrow) absolutely necessary before the actual frame?
P.S. I was able to detect the DA14580 device just fine on a BLE sniffer. So, it's working fine.
Thank you all,
Ray
Hello,
Is it possible to program the Beacon hardware with other custom or generic example code written for the DA14580?
Thanks.
Hi, I'm a newbie. I have a DK Pro of DA14583 and i downloaded source code of Beacon project. I have followed these steps to test the project Beacon:
1. Build project with Keil C 5.
2. Connect the DKP with laptop via USB.
3. Download hex file via Smart Snippets.
4. Use BlueLoupe in my smartphone to scan
But none can be scanned by my smartphone. Is there any problem here?
For the mobile app that works with the Battery powered beacon, where can I download it? Is the source code available?
Hi,
I've just started working on the DA14580 and I have an iBeacon application to develop. Knowing that there are some different specifications between the beacon developed by Dialog and Apple's one (advertising data packets and Advertising Interval). I would like to kow where can I configure the Dialog beacon to respond to Apple's specifications.
Regards.
Thank you.
I try to write the OTA NVDS data to DA14580-01 but no lucking. I'm following the DA14580 Beacon project.
Could u please provide a working nvds.hex example for me?
Hi Dialog,
A mix of hardware and software questions.
We are working on a battery iBeacon for which we require some of the beacon parameters to be updated by a maintenance app (UUID, major, minor, Tx rate e.t.c). Originally we planned to update these parameters using a patch which was updated by SPOTA, but since your new beacon reference design I see uses now uses SUOTA. If possible I have some questions relating to this application:
1. When updating only a few parameters is SPOTA or SUOTA more suitable for this application and easier for develpment?
2. We planned to use external I2C memory for the patch which I am not sure of the patch size required, but do you have any approved I2C with smaller memory compared to the versions listed in AN-B-023 which are fairly high cost?
3. We are using the Expert Dev kit, but P0_5 is currently used for the serial debug. If using external flash, how do you configure the dev kit if using external SPI Flash and serial debug?
Thanks
David