Hello Dialog,
I have an immediate requirement to eliminate the external 32KHz and 16MHz crystals for the SoC operation.
The reason being to make the system design without additional components other than the SoC.
I need all the steps to change the SDK 6.0.10 to take clocking completely from the internal RC oscillators than including the external crystals.
(#An immediate help is required. Thanks)
Thank you
regards
Raju
(HONEYWELL)
Hello, I'm trying to burn internal flash memory over JTAG. But get an error:
[ERROR SPI Flash @19-02-28 17:51:23] Adddittional error info at JTAG address 0x7FC7C0C. (MSB first): FF FF FF F8.
[ERROR SPI Flash @19-02-28 17:51:23] Memory burning failed.
I have tried two configurations:
SPI_CLK: P2_0
SPI_EN: P2_3
SPI_DI: P2_4
SPI_DO: P2_9
and
SPI_CLK: P2_0
SPI_EN: P2_3
SPI_DI: P2_9
SPI_DO: P2_4
Using the DSPS Device demo provided I am trying to add SUOTA.
I've followed the Training_06_suota_example_v1.1_0.pdf and also thehttps://support.dialog-semiconductor.com/guide/faq-da1458x-software-peri...
I've got everything to compile and I've also checked the prox reporter source code to compare.
However after everything compiles and loaded to test, I no longer see DSPS advertised in the Dialog DSPS app or see it in the SUOTA app.
Can you let me know, if you have any USB to JTAG programmer. I have been using the Eval Board JTAG pins to load the software for my prototype pcb
if you have any programmer specifically , please do share the details
I am trying to get the I2C adapter working, but for some reason it is blocking forever when I call ad_i2c_write_read().
How to Program the BLE controller. Which pin is used for dumping the code in to it.?
Please share the details.
Hello Team,
I am trying to integrate a gyro sensor with DA1586 and configure interrupt for the sensor. For basic I2C communication I used P0_2 and P0_3 pins taking i2c_eeprom as a reference and got the desired output .Now for configuring interrupt can I have any reference example and what are the hardware pins to be connected for enabling interrupt?
Thanks,
Goutham.N
Hi Team,
I am using DA14586 chip and SDK: 6.0.10.511. I use the example ble_app_sleepmode, and in user_config.h, I set the adv interval to be 1 second, by modifying struct advertise_configuration user_adv_conf. There is no problem for advertisement.
Hello,
Are there any way to upload firmware with J-Link? When I use dubugging mode it only upload firmware to RAM. But how I can upload firmware to internal flash?
Thanks
The DA14586 datasheet says in table 1 "During the boot sequence, the four SPI pins of port P2 are used to access the internal Flash memory. Therefore these pins shall not be remapped or used for any other purpose.".
Please clarify: Isn't the issue just during booting? Are we ok as long as we don't interfere with the SPI traffic during booting?
