Hello,
Using DSPS device app and code, does the module wakes up automatically when incoming data arrives? Does the device asks for permission to send data via RS232? Is there an application note describing the behavior in more detail?
I can send date from a controller to the BL module and see this data also within the DSPS app but I am not able to send data from the DSPS app to the device. I double checked all the connection and they seem functional.
Kind regards
Hello
我想使用需求方的项目(dsp 5.150.2)。我的广告ded one characteristic to control GPIO at DSPS original project.
I can check the gpio is changed when I change the value of the characteristic.
The problem is that 'BLE_WAKEUP_LP_Handler' is continuously called which is calling the 'periph_init' function so that the gpio's state goes back to default state right after changing by BLE.
Could give me some advice about this?
I'm using DSPS v 5.150.2 to communicate between a sensor and a Windows 10 PC.
The problem I am having is that after a few seconds of transmitting data the DSPS program will call ASSERT_WARNING(0) at user_periph_push. I believe this means that the read buffer is overflowing.
I have the sensor outputting to both UART (BLE) and USB(PC) at the same time to compare the data, and it seems that it is exactly the same. The sensor doesn't have flow control but the data seems to be sent out as soon as it is received, so I don't see why the buffer is being filled up.
Hi,
I am trying to get the DSPS program to perform like normal but if it receives certain data over bluetooth, and if it matches a certain command, send back some data instead of passing the data on over uart. Which functions should I use for reading and writing this data?
I'm using DSPS 5.150.2 .
Thanks
Dear Dialog_Support,
Requirement of my project is, one device as a BLE Host and another as a BLE Device. I have few questions regarding proximity example and DSPS example.
Hi,
I have successfully burned DSPS firmware to DA14580. My iOS app can successfully connect to it (I can discover the services and three characteristics), but I do not see any change in DA14580 P0.3 (UART RTS). During development, I could see a LOW signal every ~100ms before connection and every ~25ms after connection. Have you guys seen anything similar to this behavior?
Hi Dialog,
I am using the DA 14580 Dev Basic,
I had successfully send what I am typing to my smartphone through the DSPS example, now I would like to send to my computer through bluetooth comport but my computer cannot connect to the board. How do I can connect to computer?
Thank you
Jollyreal
