Is it possible to run JTAG or boot from UART if the chip was OTP programmed?
After the Application Flags in the OTP header have been programmed the serial boot sequence will not be executed anymore. In this case only programming over JTAG is possible
Kind regardsDialog Support
I have enabled in OTP header JTAG interface but still cannot program via JTAG. I have Application Flag 1 and 2 set to enable in OTP header. Can be it?
/rofe
After the Application Flags in the OTP header have been programmed the serial boot sequence will not be executed anymore. In this case only programming over JTAG is possible
Kind regards
Dialog Support
I have enabled in OTP header JTAG interface but still cannot program via JTAG. I have Application Flag 1 and 2 set to enable in OTP header. Can be it?
/rofe