I'm trying to program some DA9061s with the motherboard 232-01-B and socket board 232-02-A.
Previously I had success in both using power commander mode to test features and the ICP application to program chips, but now I can't do either. Maybe I'm missing something but it doesn't seem to be able to detect the DA9061. I've tried fresh parts and ones that have previously been OTP burned, and I've also tested the burned parts work outside of the motherboard.
Is there anything else I can look at?
Device:
你好Daylan,
你能send me your .ini file?
Kind regards,
Elliott
Hi Elliot,
Thanks for your reply, I've gotten a bit further in my troubleshooting and found that I'm getting Write Failures on two ICs that I thought to be new parts which had never been used before. Two other parts which have previously been burned seem to be working fine, but they have two different ini files which are different than the third which i would like to burn to the new parts. I don't think the ini file is to blame and I'm not sure which one to send you anyway.
The error I get when I try to Reconnect to Device is [ERROR] Write Failure (bus=i2c, slave=0xb0, address=0x0000, data=0x00).
你好Daylan,
Just so i understand, you have two sets of the chips, both with different .ini one set of parts is working and one isnt?
你能send me the .ini files for both?
Kind regards,
Elliott