The Connection Manager Discover/Connect tab is not shown after selecting "Boot as Centra.l"
Attachment:
Device:
The Connection Manager Discover/Connect tab is not shown after selecting "Boot as Centra.l"
Hi Ming-tun Hsieh,
There are quite some posts in troubleshooting the Connection manager on the support forum, please check the one posted below.
http://support.dialog-semiconductor.com/connection-manager-problem
Thanks MT_dialog
Hi MT_dialog,
I checked the posts, but could not find answers.
Everything is OK initially and ends with "Script processing completed". However When I hit "Boot as Central", the Discover/Scan tab did not appear.
Shown below is the log message:
hex2bin v1.0.10, Copyright (C) 2012 Jacques Pelletier & contributors
Lowest address = 00000000
Highest address = 00003EEB
Pad Byte = FF
8-bit Checksum = A0
Tools directory: C:\Program Files (x86)\ConnectionManager\bin\firmware_upload\
Using HEX file: "C:\Program Files (x86)\ConnectionManager\bin\firmware_upload" "full_emb.hex"
--- Generated JLink Script File ---
r
w2 50000012, A6
W2 50003308, 2e
loadbin "full_emb.bin", 0
verifybin "full_emb.bin", 0
r
g
exit
---
SEGGER J-Link Commander V4.72 ('?' for help)
Compiled Jun 12 2013 15:47:30
Script file read successfully.
DLL version V4.72, compiled Jun 12 2013 15:47:08
Firmware: J-Link OB-SAM3U128 V1 compiled Aug 28 2015 19:26:23
Hardware: V1.00
S/N: 480055663
VTarget = 3.300V
Info: Found SWD-DP with ID 0x0BB11477
Info: FPUnit: 4 code (BP) slots and 0 literal slots
Info: Found Cortex-M0 r0p0, Little endian.
Found 1 JTAG device, Total IRLen = 4:
Cortex-M0 identified.
JTAG speed: 100 kHz
Processing script file...
Reset delay: 0 ms
Reset type NORMAL: Resets core & peripherals via SYSRESETREQ & VECTRESET bit.
Writing 00A6 -> 50000012
Writing 002E -> 50003308
Loading binary file... [full_emb.bin]
Writing bin data into target memory @ 0x00000000.
Loading binary file full_emb.bin
Reading 16108 bytes data from target memory @ 0x00000000.
Verify successful.
Reset delay: 0 ms
Reset type NORMAL: Resets core & peripherals via SYSRESETREQ & VECTRESET bit.
Script processing completed.
====> [18:35:17.570] Rx <====
UART COM11 Open
====> [18:35:17.587] Tx <====
Src Task : 0x3f (TASK_APP)
Dst Task : 0xd (TASK_GAPM)
味精Id : 0x3402 (GAPM_RESET_CMD)
Operation : 0x01
Payload : 02 34 0d 00 3f 00 01 00 01
After selecting "Load Firmware..", and selected full_emb_581.hex, it worked.