Hi All,
Experimental Setup: I tested the Evothings viewer with the tablet Teclast-TPad X80H. The firmware that I used in IoT Sensor is 5.160.01.19.
Problems: I found a Connection error 133 when trying to connect the IOT sensor.
However, when I using Huawei, it works properly.
Questions: Could you please give me some hints why this happened and how to modify the code on the IoT sensor?
Best Regards,
Yufan
Keywords:
Device:
Hi Elvis1991,
I dont think that its a fw matter that fact that you cannot connect to that specific tablet, you will have to snif and check the reason for that error, additionaly this might also be an android issue on some devices and not problem of the IoT fw.
Thanks MT_dialog
Dear MT_Dialog,
Thanks for your answer.
I got it. I think it is an android issue as well.
I wonder that if you mean that I am supposed to grab the communication package to analyze the error?
Best Regards,
Elvis
Hi Elvis1991,
You could use a sniffer log and check why that happens, perhaps the tablet device sends a request that the other side is not capable of processing it, and that is the reason you get that disconnection.
Thanks MT_dialog