⚠️
Hi there.. thanks for coming to the forums. Exciting news! we’re now in the process of moving to our new forum platform that will offer better functionality and is contained within the main Dialog website. All posts and accounts have been migrated. We’re now accepting traffic on the new forum only - please POST any new threads at//www.wsdof.com/support. We’ll be fixing bugs / optimising the searching and tagging over the coming days.
2 posts / 0 new
Last post
Wed, 2020-02-05 10:35
#1
apellkof
Offline
Last seen:10 months 3 weeks ago
Joined:2019-01-15 10:33
DA14586 design questions

Hello,

I am about to move my design from the DA14580 to the DA14586 since the old part is not recommended for new designs and I would make use of the internal FLASH.

My understanding is from a schematics point of view, only two pins are different:

#5 (VCC_FLASH) is used to power the FLASH. On the 14580/5 it is nc.

#38 (VDD) is recommended to float. On the 14580 it was VPP and used only when programming OTP (supply 6.7V).

I hope this is correct so far?

However, the Eval Board with the DA14585 (e-da1458xdevkt-b-vb00.pdf) still shows a circuit to generate VPP supply. So to use OTP memory, is VDD/VPP supply required or can VDD pin be always floating?

Thank you

Andreas

Attachment:
PDF iconDA14586 schematic
Device:
DA14586
Wed, 2020-02-05 13:31
PM_Dialog
Offline
Last seen:2 days 9 hours ago
Staff
Joined:2018-02-08 11:03
Hi Andreas,

Hi Andreas,

Many thanks for your question on our public Bluetooth forum. If you are OK, we’ll take your question offline onto mail. Let me check it and I’ll send you an email in your registered address as soon as possible.

Thanks, PM_Dialog