Hi dialog
I am working on a DA14681 based board. I want to communicate between two DA14681 via I2C. One in Master mode other in slave mode. But i couldnt find documentaton or example in sdk regarding this.
Can you help me in this regard?
Hi Dialog,
As we know, DA1469x has a Bare Metal Blinky example. Could you provide a similar example for DA1468x?
Thanks, Peter
Hi dialog
我使用基于DA14681的板，我想使用6个热敏电阻，并且我必须使用一个与SWD引脚共享的ADC引脚，（SWD CLK和SWDIO）。
I confured this pin but it didnt work, then from this query i came to realize that debugger needs to be disabled for this pin to work, (https://support.dialog-semiconductor.com/forums/post/dialog-smartbond-bl...)
但仍然没有进展。
Dear Dialog,
i implemented a da14681 on a custom system on chip.
My system runs on a lithium ion batterie.
My problem is that the socf function is crashing my system when activated, the board is not booting and thus it is not possible debug easily.
I implemented a workaround in which i retreive manually the battery voltage through the ad_battery_raw_to_mvolt() function and then calculate the battery level through linear regression.
Hi Dialog,
I am using DA14683 ProDK board and SDK version is DA1468x_DA15xxx_SDK_1.0.14.1081
I want to test battery charge function in the ProDK board but it seems not work!
The following are my settings:
(1) Use pxp_reporter project in SDK and uncomment #define DEBUG_SOC in custom_config_qspi.h
(2) Connect Lithium battery(500mAh) on J10(pin1: VBAT- to battery negative terminal, pin 2 to battery positive terminal, pin 3 NTC is not connected)
(3) Switch SW2 on the daugtherboard to VBAT
(4) Place jumper on header J9, on position 1-2
Hi,
我正在尝试在DA14683开发套件中与ST7735进行液晶显示器和生物传感器。
Both ST7735 and bio sensor are SPI bus protocol. I want to set ST7735 on spi 2 and bio sensor on spi 1.
I had test ST7735 on spi1 and it is work.
However, I modify st7735 from spi 1 to spi2, csn pin is work but the clock and mosi pin do not output signal.
Measurment result as attached file.
Is there any parameters or api need to setup?
//************* modify st7735 from spi 1 to spi2
SPI_BUS(SPI1)
Hello,
the download of the latest SmartSnippets Studio (2.0.12) is broken. There is only v1.6.3 available anymore. When I install this version I get an error, that my workspace was created with a newer version.
Can you please check your website?
Best regards
Jens
Hello,
I'm evaluating the DA14683 using the DA14683-USB DK. I've compiled and loaded the DialogSemi\projects\workspace-ble-adv\projects\dk_apps\features\ble_peripheral project. After pressing restart I can see the device's advertisements in my BLE development app, and can even connect. However, after ~10 seconds the device disconnects/crashes. I have to hit the reset button again to restart the device, at which point it crashes again after ~10 seconds. It looks like most of the da14683 tutorials and demo code are for the da14683-basic and -pro dks.
Hi dialog,
I'm currently learning on DA14681 wearable.
I just figured it out while scanning, it capture services like sending notification with write permission.
Is there any way to hide that services not being able to be captured?
