I have a couple of questions regarding flow control as implemented in the SPS. I'm using the PAN1740.
1- Whats is the difference between software and hardware flow control?
2- Where one can select between software and hardware for flow control?
3- Where exactly one can configure the pins used for this purpose?
Thank you!
Hi dear support,
I'm trying to implement low power mode for project developed without this support.
I found a number of bugs when I define GFG_EXT_SLEEP.
实际上,我只有一个悬而未决。
At software architecture button pressing for predefined long period (more then 10 seconds) results a reset of device.
For that purpose in button callback timer was implemented. And it works properly in active mode, but not in extended sleep.
Hi there,
I was trying out the prox_reporter example project provided within the Dialog SDK file (SDK ver. 5.0.2.1), and realized my advertising packet seems to go undetected by my BLE USB dongle at irregular interval. The initial setting for the interval timing under "user_config.h" was 1100 and I changed that to 800 (for 500ms). The exact variable I changed is user_undirected_advertise_conf.intv and user_non_connectable_advertise_conf.intv (just to be safe).
DA14580是否有掉电存储的位置，类似E2Prom。
如果有是否有相关例程呢？
设备使用随机地址，这个错误不是必现的，请问下这个是为什么？
Hello MT_dialog,
I use the DA14580 development Kit-Basic and with the AN-B-023 I successfully loaded my project into the Flash memory (W25X20CL) and booted from it using SPI.
Now, I want to connect it to an STMicroelectronics STM32F103R8 using SPI, is it possible to load my project into it's internal flash memory and boot from it as I did with the DA14580 ? Or should I I implement a booting protocol in the ST Microcontroller to send data over SPI to my BLE module (slave) ?
Thank you very much and regards,
-- Saif
