White background figures
Forums:
Dear
When the simulations are done, is it possible to get the plots in white background?
Thank you
DA1458X Mass production
Hi All,
Can anyone help me with how to program the DA1458x mass devices? I am in the production state of my few devices.
And I have one doubt regarding assigning mass BDA to devices,
In my project, I have used BDA as one of the parameters, using that I am performing some controlling operation. So in the mass production time will that affect my project.
Haptic Driver: DA7281
Hi,
Where can I order couple of EVKs for DA728x series haptic drivers? We tried to contact through your portal but wasn’t able to get any response
Thanks,
ADC output to UART format
Forums:
How to transfer output (either serial or parallel) from ADC into UART format (no parity, 8 bits, 1 stop bit) at baudrate (example: 9600 baud)?
MSbit or LSbit leading doesn't matter.
Are there any examples?
Getting noise from DA7212
Hello Team,
We are working on ERAGON410 board based product and linux Linaro-18 platfrom. We are using DA7212 in slave mode and set MCLK to 9.6 MHz.
#1If we apply below commands which will play directly from AUX, We can hear the noise in the HP if the volume level is more then 55-60%. Here we are not playing anything at AUX side.
width pulse in counter
Forums:
Dear
I am using the SLG46620 device and the CNT components as counters, I would like to know if the width of the geerated set can be changed or is it by default.
Attached image.
Another question regarding this would be if it is possible to generate a pulse half the width of the one provided as an attachment in image 2.
Thank you
Regards
DA9061/62/63 Motherboad no longer working
Hello,
We're developing a product that is using the DA9061 PMIC and have been using the motherboard dev kit to test it. Recently it stopped working as I can no longer connect to blank chips using the DA9061 GUI software.
If I place a blank chip in the socket I immediately start getting I2C errors and i can never get past them. If i place a programmed chip in the socket, the software seems able to connect normally.
Thanks,
Daylan O
蓝牙设备绑定问题
你好：现在我的蓝牙设备需要绑定，但不需要配对码，使用下面配置：
RoHS Declaration for SLG59M1557V
Forums:
Dear Sir,
Would appreciate if you could be provide me a copy of SLG59M1557V RoHS certificate.
Thanks.
Regards,
lisa
需求方透传停止工作的g after much data sent from UART
Hi there,
I working a project base on DSPS project of 14580, and I modify the following changes for the default DSPS project:
1. #undef CFG_MEM_MAP_EXT_SLEEP
2. change app_default_sleep_mode value to ARCH_SLEEP_OFF
3. change GPIO_UART1_RX_PIN to GPIO_PIN_2
4. use CFG_UART_SW_FLOW_CTRL instead of CFG_UART_HW_FLOW_CTRL
Pages
