We are using SLG46538V in our custom board. We want to debug the design via PC using GreekPak5 Designer.
Can we use SLG4DVKISP (http://www.silego.com/buy/index.php?main_page=product_info&cPath=66_74&products_id=727) to interface GreekPak5 Designer running on PC with SLG46538V on our custom board?
Hello
We are looking for the lowest power Wi-Fi solution that can be used to for audio streaming and voice communication in a headset.
We want to run a teams/zomm or similar client in the professional headset. This means that it will be batterypowered. So target is min 10h talktime on a 750 mAh battery..
What is possible with dialog chipsets/modules. BT is also needed but that is not a power challenge.
This could be an candidate DA16600 but I can't find the power consumption data in different modes. Wi-FI could be a fall back mode if BT is not avalible.
Hi，
看到文件格式是dsn和brd，dsn是原理图已经用cadence 的capture打开了。但是brd文件打开错误。
请问brd具体需要什么软件？什么版本？
谢谢
Hello
I would like to know if the SLG46620-A can be qualified as AEC-Q100 Grade 1 (-40C to +125C).
Best Regards
Caio
Dear,
I want to know that whether I can reconfigure the integrated components(resistor, capacitor, etc.) to make desired analog circuit in GreenPAK or not.
I'm using the model SLG46517M, and I want to replace the discrete components with a one simple chip(GreenPAK).
Is it possible?
And there's one more question, are there any ways to synthesize the programmed GreenPAK with verilog or other simulation tools?
I want to simulate the whole system which is composed of my external circuit and GreenPAK chip.
Thank you,
Dear
When the simulations are done, is it possible to get the plots in white background?
Thank you
Hi All,
Can anyone help me with how to program the DA1458x mass devices? I am in the production state of my few devices.
And I have one doubt regarding assigning mass BDA to devices,
In my project, I have used BDA as one of the parameters, using that I am performing some controlling operation. So in the mass production time will that affect my project.
Hi,
Where can I order couple of EVKs for DA728x series haptic drivers? We tried to contact through your portal but wasn’t able to get any response
Thanks,
How to transfer output (either serial or parallel) from ADC into UART format (no parity, 8 bits, 1 stop bit) at baudrate (example: 9600 baud)?
MSbit or LSbit leading doesn't matter.
Are there any examples?
Hello Team,
We are working on ERAGON410 board based product and linux Linaro-18 platfrom. We are using DA7212 in slave mode and set MCLK to 9.6 MHz.
#1If we apply below commands which will play directly from AUX, We can hear the noise in the HP if the volume level is more then 55-60%. Here we are not playing anything at AUX side.
