Hi, I have several problem regarding my project
so what I've done till this very time after I receive some of your suggestion.
So i have put my soldering temperature under 250 degrees during the installment, and there's no short and problem with my IC.
Therefore I put all of needed port in my device, with precaution if there's anything wrong with my module.
I tried to consult my module, most of my design is almost exactly the same with SmartTag
Dear Dialog_Support,
Is it possible to call "user_app_adv_undirect_complete" function in user space except user_callback_config.h file? If yes then what should be the argument? Here the function "void user_app_adv_undirect_complete(uint8_t status)" has "status" as argument so during function call what should be used in place of "status"?
With Regards,
Ruchi Patel
Hi!
我试图create a circuit with the TDK Module.
According to the datasheet the module has the same Pins as the DA14580 Chip.
Can I use the same pins for the ADC measurement? And how can the pins be changed
从例如数字I / O到ADC输入？
I found the following image in the datasheet. Is it possible to use this circuit and just have the wanted P0
pins for the ADC measurement connected differently? And what do I have to watch out for when designing
the circuit?
Kind Regards,
Reichel Robert
Hi,
I am having troubles with the ble_peripheral example.
How do I add an characteristic where I can read ADC values? Just reading dummy values would be enough for the time being,
but I can not manage to advertise dummy values to read with my smartphone. Even the existing ADC 1 and 2 Characteristics
do not show me any data.
Kind Regards,
Robert
Hi everyone. my name is Kevin.
I'm facing the problem like in my attachment. i have a chip which is attach to my custom board, and i want to burn my program in it. but before that, i need to flash a bootloader right?
i connect the chip using uart, with pin configure as vcc, gnd, p0.4 and p.05. but then the reset pin dosen't detect on smart snippet. what i have to do? thank you
Hello,
I would like to know if it is possible to enable Notify and Indicate Property in the same characterisic within SDK.
Thanks
Hello Dialog,
at first, let me cralify our situation for the subject. Our issue is almost same as below link,
https://support.dialog-semiconductor.com/ble-stack-doesnt-receive-discon...
The difference is only SDK version. We're using SDK3.0.10 because our product had launched over 1 year ago, but we still need to custamize the system function for our specified customer based on SDK3.1.10. Then, we encounterd this kind of issue.
Basic Design Kit for development
DA14580 (Murata module on custom board)
SDK 5.0.4
Hello,
I want to buy your BLE evaluation kit, but would like to make sure I can use it for my custom application first. I want to use the kit to transmit non-connectable advertisement packets. I want to have control on the timing gap between packets at a given advertising event. Is that possible with your BLE stack ? My goal is to go as low as 50usec beween packets in one event.
Thansk
