Hi Dialog Support Team
I am using Murata P2ML 3656 BLE Dev Kit it uses the same configuration as DA14580 PRO dev kit.
Q1 : In my murata board UART is not working,
- i ran UART code no data in UART
- i tried smart snippets UART boot loader no reset happening, so not able to run booter
- i connected RS232 externally , now i am able to see data via UART
but FTDI device is detecting in windows Device manager......what could be the problem ???
Hi Dialog
是其他e any plan of making Dialog BLE OCF certified Devices?? if yes when ??
For Reference :https://openconnectivity.org/announcements/open-connectivity-foundation-...
Thank you
Hello
查看当前（测试版）状态如果是亚非排序的命令解决方案，那么似乎没有可能：
- as a CENTRAL / GATT client, to discover GATT serv/chars and then query the PERIPHERAL / GATT server to READ, WRITE, subscribe to NOTIFYs, etc.
- as a PERIPHERAL / GATT server, to define a set of services and characteristics.
是其他e something planned in this direction ?
Many thanks
Veranith
hi everybody!
My name is Kevin.
i have a custom board specialize design for da14580 and a devkit-B for da14580. when i tried to debug blinky code to da14580 on devkit, it is successfully run and the led blinking periodicaly.
but when i debug blinky code to my custom board, the red led on devkit near the usb did'nt turn on, and the command log on keil show this:
Hi,
DA14580 is in peripheral mode. We want to transfer data to it through a central device (mobile phone) for performance testing
是其他e any sample app using which we can send some data so that the connection event length will be longer (to keep high duty cycle of the BLE transmission).
谢谢，
hrishikesh.
Hi,
I am using the ble_app_peripheral app. When I connect to the DA14580 through a mobile phone and keep it connected, I see that the link disconnects after some time.
I want to keep the BLE connection intact forever.
是其他e any change that can be done in the app in this regard? If yes, how it can be done.
HI, I am trying to test OTP programming, but when I start to burn OTP to my 14580 chip, I found that there are already some data in the address range of 0x40000 to 0x41600 and the software also warn me that "memory segment already burned!"
So do my 14580 is already broken? what should the OTP looks like when it is new? or I have to set some kind of offset to do the burning? please help me.
My account has been activated by mail notification, but it is still not possible to download the information.Please look at it. Thank you.
Hi Dialog,
I am developing a SPI slave driver for DA14580.
When communication is performed by writing data of 1 to 2 bytes on SPI_DATA 0 on the slave side, data written on the slave side is read on the master side and Logic Analyzer.
When communicating without writing any value in SPI_DATA0 on the slave side, 0xC0 is read on Master side and Logic Analyzer.
According to 96 Page of DA14580_DS_3 v4.pdf, the Reset value of SPI_DATA 0 is 0x0.
Therefore, I do not know the reason why 0xC0 is read on Master side and Logic Analyzer.
Hello!
I followed thehttps://support.dialog-semiconductor.com/step-step-guidelines-programmin...forum to program the OTP. After I did it my custom board didn´t work properly until I used the booter to load the program and i was working perfectly. Then the battery ran out and after charging it the device stopped working. I tried to connect the custom board to SmartSnippets to check it but i get the following message.
