GPAK interface with RTC
Is it possible to connect a Real Time Clock (RTC) directly with a GPAK CMIC?
Is it possible to connect a Real Time Clock (RTC) directly with a GPAK CMIC?
Hello
I want to add extended sleep mode to the ble_app_peripheral project in SDk 5.0.4. Unfortunately, sleep mode does not appear to work. I used training_04 to do this. Can you try it out and let me know the steps you took to successfully enable sleep mode?
PS I'm using the Basic dev board with SPI Flash. The current I see is about 3.4mA with sleep enabled and disabled.
thank you,
What is a suitable way to connect a GPAK device to the internet for IoT applications?
Is there additional hardware required for the in-system programming of the new SLG46826V boards? The new update of GreenPak Designer mentions an in system programmer board SLG4DVKISP under the Debug tool options, however I see no mention of this part on your website. Can the programming be done with the Advanced Development Platform?
Hi,
I have a firmware project in Keil that I need to generate a hex file from for OTP burning. I am confused about the configuration in the firmware, namely what changes (if any) are required for OTP. I have found the following variable in da1458x_config_advanced.h:
#undef CFG_BOOT_FROM_OTP
Does this variable need to be defined in order to burn the firmware to OTP? Are there any other changes that need to be made? The firmware has been developed from ble_app_peripheral from the DA14580 SDK.
Cheers,
Tony
I'm trying to get the ALC (Auto Level Control) working in the DA7212 for analog microphones, but haven't been able to get the ALC to have any effect on the audio output.
我的设置音频路径是:
2 Analog Mics (pseudo differential) --------> DA7212 Mic Inputs ---> DA7212 DAI --------> Processor (wave capture).
I know I have the DA7212 setup correctly as I can get audio through this path, as well as send it back to the DA7212 HP outputs.
What is the current recommended SDK for new projects using the DA14580?
What is the Dialog/Silego recommended way for creating a signal that is asserted after a specific duration (for example, 2 hours) after powering up the chip?
Do you intend to put out ECAD models for these parts? Always nice to not have to build a part.
Hi,