Hello Dialog,
I have a da14681 development kit basic board and i have programmed PXP_Reporter demo code into board. when i connect UART RX pin (P2_3) to TX pin of USB2Serial Module, the BLE part of the code crashes in 8 seconds after the reset. i disabled the sleep mode with this code (pm_set_sleep_mode(pm_mode_active);) and also disconnected the j13 jumpers but there was no any changes. do you know what is the problem?
thanks ...
Hello,
I am working on a project based on the IoT SDK v5.160.1.19 using the Murata ZY moduel with DA14580.
I have modified the firmware such that my board works well with the IoT APK.
I am using P1_4 and P1_5 as GPIO to sink LED current, e.g. to have blinking LED for BT indication.
Hello,
Where could I get the detailled information (schematic, code) about the "Indoor light powered beacon" ref design :
//www.wsdof.com/products/connectivity/bluetooth-low...
I don't find the way !
Thanks
Aurelien
Hello Dialog_Support,
您好：
我使用的DA14580芯片，通过JTAG口连接，使用SmartSnippets Studio v1.6.3.918版本烧写程序。
请问image header nvds 都需要烧写吗
烧写image 时，烧写完成，见附件
烧写header时，烧写不进去，麻烦帮我看一下是什么问题？谢谢。
Hi Dialog
We have a project based on a DA14581 chip, which requires the use of AES-CCM functionality. I can see that this feature (API) is present in the SDK 6 version (for the DA14585/6). But we want to use it on the SDK 5 for the DA14581. Can this be back ported without any big trouble?
Kind regards
Thomas Lykkeberg
Check out the app note below to look into the use of Dialog's nFET integrated power switches in solving some common problems caused by powering up on high capacitive loads:
请问有将芯片设为Central的参考例程吗？
Hi
I am looking for a PCB (and antenna) designer.
is there any service available through this forum. or else please refer me some good hardware design engineer.
Thanks
Paramvir
您好：
我们移植了SDK5.0.4中SPI主从模式的proximity工程。 在HadleGapmCmpEvt收到GAPM_SET_DEV_CONFIG回应后开启Scan. 能够正常scan到周围设备的广播包。 但是scan过程只持续了6s左右，就收到了scan结束的消息，错误码0x45 GAP_ERR_TIMEOUT. 如下是scan的log和scan的参数。 请问要如何修改才能保持长时间持续扫描，谢谢！
