Hi,
I'm trying to debug a DA14531 using arm-none-eabi-gdb and JLinkServerCL. Can you please provide the commands I need to load the program bin/hex on to the RAM? I tried using the loadbin JLink command but I keep getting this error "Writing target memory failed.".
Thanks
Gowtham
Good day, and sorry if this was asked before, but I couldn't find anything that addressed my question.
Hello,
I am using the DA14531 module with your DSPS software (dsps_device_531.bin, v6.150.4.50).
When I change the device name via the SmartConfig app (downloaded on the PlayStore) and then I restart the DA14531 module, the name is also resetted. So i'm looking for a solution. Can I change the name via Bluetooth and make it permanent even if I restart the module ?
或另一个解决方案,我将会改变name via UART. Is it possible ?
Thank you,
Have a nice day.
Noé
Hello. Dialog Semiconductor team,
我是矩形ently known about your BLE low energy devices, I was very much attracted to your products.
1. I want to interface a sensor with DA14531MOD via I2C connection and send that data to another DA14531MOD. I am not able to find a proper reference from your site regarding sensor I2C integration with DA14531. I am only able to find I2C_EEPROM in SDK peripheral examples.
2. Where can I start a new project to develop as my requirement. I haven't seen any possible way for that. Please help me.
Hi,
I'm trying to implement any sleep mode on the DA14531 which does not cause a system reset. Can you please provide which sleep modes cause a reset and if a specific sleep mode does not trigger a reset, where does the execution continue from and what will be the state of the BLE connection?
From looking at the proxr_reporter code,
Extended sleep - Continues execution on wakeup
Deep Sleep - Triggers a reset on wakeup
Hibernation - Continues execution on wakeup
Hi,
I'm using a DA14531 Done in a Day kit with an IMU. I'v modified the ble_app_profile example to interface with the IMU and transmit the IMU data.
When I used I2C_SPEED_FAST, I observed that only zeroes are sent on the line and my code hits the NMI handler after few seconds. In the periph_init() function, I initialized the I2C peripheral and I'm reading the IMU's WHO_AM_I register continuously in a loop till I receieve the correct value. I used a logic analyzer and observed that only zeroes are sent.
Hi there,
Does DA14531MOD (DA14531 SmartBond TINY™ Module) comes with preloaded firmware. If yes, what is the firmware?
Dat.
Hi,
Hi Dialog,
i am using DA14531MOD-00DEVKIT and i am using da14531 daughter board. and i want to interface and i2c temp slave and send it to mobile so any suggestions on how to da that
Hello,
I have a new problem, I am using the development kit with the DA14531 module. I flashed the module with dsps_service_531.bin and I'm using your Android app SmartConsole downloaded on the PlayStore.
When I send a character with TeraTerm on my Windows computer to the module, I don't receive it on the app. But if I send quickly a lot of characters, I will receive them. For example if, on TeraTerm, I maintain the letter "a" pressed, I will receive a lot of "a" on the app after a little delay but if I press only one time the letter "a", I will not receive anything.
