Hello hrg, the application note below describes the generic set-up for the different ways to measure the current on the DA14580 : whilst i referneces buck mode, the same techniques are applicable to boost mode (just note the jumper config settings on the motherboard etc. need to be correct).
Hello hrg, the application note below describes the generic set-up for the different ways to measure the current on the DA14580 : whilst i referneces buck mode, the same techniques are applicable to boost mode (just note the jumper config settings on the motherboard etc. need to be correct).
http://support.dialog-semiconductor.com/resource/b-015-da14580-supply-current-measurements
THanks &BR JE_DIalog
Thankyou JE_Dialog