⚠️
Hi there.. thanks for coming to the forums. Exciting news! we’re now in the process of moving to our new forum platform that will offer better functionality and is contained within the main Dialog website. All posts and accounts have been migrated. We’re now accepting traffic on the new forum only - please POST any new threads at//www.wsdof.com/support. We’ll be fixing bugs / optimising the searching and tagging over the coming days.
7 posts / 0 new
Last post
Tue, 2020-08-25 15:47
#1
gme_johannes
Offline
Last seen:18 hours 18 min ago
Joined:2017-12-22 10:09
SmartSnippets超时

Hello Dialog support,

I am working on a script using SmartSnippets to program via UART. In our programming jig the connections are sometimes bad, and the programming fails with messages like

  • Timeout while waiting to receive the most significant byte of packet length (10000 msecs)
  • Timeout: Reset signal not detected for more than 16000 msecs.

I would like to drastically lower those timeouts, to recover faster from this condition. In the help file which for me is in/Toolbox/common_resources/SmartSnippetsToolbox_Help/cli/command_line_if.htmlI can not find any information about parameters influencing the timeout. Is there maybe an undocumented switch?

Thanks,

Johannes

Device:
DA14585
Wed, 2020-08-26 12:14
PM_Dialog
Offline
Last seen:3 hours 50 min ago
Staff
Joined:2018-02-08 11:03
Hi gme_johannes,

Hi gme_johannes,

Probably you should check the connection between the JIG and your custom board and make them more stable, use shorter cable etc. There is not any document to change the time out - but I will ask internally to check this out.

Thanks, PM_Dialog

Tue, 2020-09-08 09:13
gme_johannes
Offline
Last seen:18 hours 18 min ago
Joined:2017-12-22 10:09
Hi PM_Dialog, were you able

Hi PM_Dialog, were you able to find out about this timeout?

You are right, ideally I would mitigate all problems, but it is a mechanical complication with the holding structure, which I can not fix as easily. This causes a bad contact on occasion.

Thanks,

Johannes

Wed, 2020-09-09 14:11
PM_Dialog
Offline
Last seen:3 hours 50 min ago
Staff
Joined:2018-02-08 11:03
Hi gme_johannes,

Hi gme_johannes,

Apologies for the delay but I haven’t found that time out. I’ll get back to you by the end of this week.

Thanks, PM_Dialog

Fri, 2020-09-11 11:54
PM_Dialog
Offline
Last seen:3 hours 50 min ago
Staff
Joined:2018-02-08 11:03
Hi gme_johannes,

Hi gme_johannes,

We have escalated this to our Tool experts to check if this is configurable.

Thanks, PM_Dialog

Tue, 2020-09-15 15:19
PM_Dialog
Offline
Last seen:3 hours 50 min ago
Staff
Joined:2018-02-08 11:03
Hi gme_johannes,

Hi gme_johannes,

对不起我回复晚。Changing the timeouts is not possible as the values are hardcoded and will require to be changed in the new release.

Thanks, PM_Dialog

Accepted answer
Tue, 2020-09-15 20:56
gme_johannes
Offline
Last seen:18 hours 18 min ago
Joined:2017-12-22 10:09
Hi PM_Dialog,

Hi PM_Dialog,

thank you for getting to the bottom of this. Maybe this will find its way into future release of SmartSnippets.

Thanks,

Johannes