Hi,
in AN-PM-080 it says in the revision log "Replaced DA9062-00 with DA9062-A0". Is this -A0 the correct (new) part number? The quotation we got from our distributor reads -00. Can anybody bring some light into this?
Thanks,
Thomas
Device:
Hello Thomas,
The -00 and the -A0 parts are the same parts. We made the change from the -00 to the -A0 for traceability reasons. This is a relatively new change, so it might take some time for the new PN to filter through. However, as I have mentioned, the parts are the same, so there should be no issues with programming the parts.
Will these parts be used for In-circuit programmed or for prototypes?
Kind regards,
Elliott Dexter
Hi Dexter,
thanks. We plan to use ICP. Shall we use the -A0 name in our BOM?
Regards,
Thomas
Hello Thomas,
My suggestion would be to use the -A0.
Kind regards,
Elliott Dexter