I have downloaded the SmartCanvas application and created an ini configuration that I would like to load onto my DA9062 in circuit.
Does the SmartCanvas application support off-the-shelf USB-I2C dongles, or is the DA9062 Eval Board the only way to program using this GUI?
Both the DA9062 Eval Board and ICP board are not in stock on most supplier websites. Is there a recommended USB - I2C dongle that I can use instead?
Thank you
Device:
Hello Hwaschura,
The DA9062-10 has already be programmed with the -10 OTP. So, there should be no need to re-program the PMIC.
Due to the PMIC being programmed, you will not be able to over program a large majority of registers, we can change a 0 to a 1, but not a 1 to a 0. However, once the PMIC has successfully started up, you can write to most registers, the change will be lost after an OTP reload.
Kind regards,
Elliott Dexter
Where can I find the configuration information for the -10 OTP variant?
Thank you
Hello,
Do you have a DA9062 Eval board? or do you have a referance design?
Kind regards,
Elliott Dexter
We have a DA9062 Eval board, and we have also incorporated the DA9062-10AM1 into a new design.
Please let me know where I can find the configuration information for the DA9062-10AM1.
Thank you
Hello,
I will send you the .ini file directly. You can then load it into the DA9062 GUI. This will allow you to check the register settings.
Kind regards,
Elliott Dexter
Thank you,
To be clear, this .ini file will hold the settings that come pre-programmed on the DA9062-10AM1?
Hello,
是的,这是正确的。
Kind regards,
Elliott Dexter