Hi,
I bought a da14683 dev kit usb and i tried to program with a ble advertise example. Unfortunately I didn't get it running in a way to go ; i can program and debug but it seems to restart on
cm_lp_clk_init。
Anyone can help me to have a BLE example running on the evel kit ?
thanks.
Marco
Device:
嗨garzola,
I tried to program the DA14683 dev kit USB with the ble advertise (ble_adv) demo example of the SDK, but I am not able to replicate your problem. I am able to download firmware to the chip, and it is advertising correctly. Did you use the default demo example as it is on the SDK or did you modify it? Furthermore, could you please upload a screenshot from the cm_lp_clk_init function when you run the example in debugging mode in order to see where the code crashes?
Thanks, PM_Dialog
maybe i got it... If I erase the qspi and program it with the tool and not with smartsnippet it works.. the problem i had i was debugging code not synced. Now another issue ,why I cannot program qspi from the IDE ? it gives me
Downloading 936 bytes @ address 0x08000000 - Verify failed
thanks
Ok , step by step i got it. I had to flash the qspi with the script , once done the FW starts and also the demo BUT after a while (10 sec) it disappears from the BT.
I have to reset the board to get it running again..tested on release and debug as well...any tip to solve my issue ?
I'm on linux .
Hi ,
I found out that if i switch to LP_CLK_RCX seems to work.... any idea?
Hi again...
no way ..it works for a while but it restarts...i cannot stay connected with the phone for more than 10 sec.
maybe i'm doing something wrong but i followed the guides and seems correct.
i appreciate any help.
Marco
嗨garzola,
I am a little bit confused with your last posts, and I am not able to understand which your problem is. So, could you please clarify your problems and the steps you are following in order to give you the correct guidelines?
Thanks, PM_Dialog