Hello,
I bought Production Line Tool and would like to use it in following testing items:
- Program software to SPI Flash
- 16MHz Trimming
- Write BD Address
I could succeed in 16MHz trimming test using your sample GUI Tool software. (located in DA14580_Production_Line_Tool_v_3.170.2.36_custom\executables)
But I can't program the soft using GUI tool when I try to program a firmware to SPI Flash memory in DA14583.
它们之间有什么区别?为什么我got error for writting the Flash??
I used your sample GUI Tool Software. On DUT side, we plan to use P0_2, and P0_3 for UART communication. Do we need to prepare prod_test.bin file to communicate with PLT from our environment? (As I mentioned, I can succeed to trim 16MHz value though..)
I attached the debug log file for PLTD_DLL, U_DLL and P_DLL. (Please remove .pdf. I attached ZIP file.. ) I also attached .ini file for GUI tool software configuration. I need to prepare the Writing/Test machine in our factory line in next week, so if you could respond as soon as possible, I would much much appreciate it.
Thank you very much for your support as usual.
Best Regards,
CD
Hi CD,
I ve notified the local team and they will contact you directly about this.
Thanks MT_dialog
Thanks MT,
I'm looking forward to receive any information from them.
Best regards,
CD
I don't find DA14583 option in Hardware configuration.(Production line tool-v3.170.2.36).
I'll burn my Production .
Thank you very much for your support as usual.
Best regards.
TEL:+86+18950419527
Hi dairylcs,
The 583 is a 580 with an internal flash, and the 580 option should be used in the Device IC. Also in case you burn the flash please make sure that the correct pins for the 583 internal flash are selected.
Thanks MT_dialog
Dear MT_dialog,
I a using DA1458x_DA1468x_PLT_v_3.1 to burn chips massivelly. I would like to use 14583 or 14680 to remove external FLASH memory, but I can not find the selection options in PLT V3.1 tool -> HARDWARE SETUP -> DEVICE IC, is anything wrong with my understanding or operation? Thanks!
smdzjl007
Hi smdzjl007,
I dont understand, what you would like to do, what do you mean use the 14583 or 14680 to remove the external FLASH memory. If you are trying to burn a 583 chip instead of a 580, there is no special option for the 583, just choose the 580 option and select the proper SPI pins that match the 583's internal SPI, just as i mention on post #5.
Thanks MT_dialog
Understand, thanks a lot!