I use the DSPS code for my custom board that boots from EEPROM. There is no reset button on my custom board and eveytime the i2c booting is finished, the app does not run until I connect the developemtboard and press the reset button on it.
Other firmware e.g. Peripheral_setup does not have this problem and runs when I connect the battery.
我怎样才能解决这个空间站ue? Is there anything in da14580_config.h that is stopping the app to run until a hard reset is done?
谢谢你！
Device:
Hi behzad,
I dont get the problem, if you power on your device it doesn't boot although you 've burned it using smart snippets and applied the bootable option ? There isn't any option in the da14580_config that would prevent the device from booting from eeprom.
Thanks MT_dialog