User Manual¶
SmartSnippets™ Toolbox
UM-B-083
Contents
- 1. Terms and definitions
- 2. References
- 3. Release Notes
- 4. List of Figures
- 5. List of Tables
- 6. List of Codes
- 7. Introduction
- 8. Getting Started
- 9. Board Setup
- 10. Booter
- 11. Power Profiler
- 11.1. Power Profile basic usage
- 11.2. Power Profiler software cursors
- 11.3. Power Profiler control panel
- 11.4. Power Profiler Chart Controls
- 11.5. Power Profiler Data
- 11.6. Power Profiler Chart Views
- 11.7. Chart management via mouse
- 11.8. Chart management via keyboard
- 11.9. Power Profiler configuration
- 11.10. Calibration Procedure
- 11.11. Power Profiler special properties
- 12. Sleep Mode Advisor
- 13. Battery Lifetime Estimator
- 14. OTP Programmer
- 15. SPI Flash Programmer
- 16. EEPROM Programmer
- 17. Program SPI/EEPROM
- 18. Proprietary Header Programmer
- 19. OTA Services (over the air services)
- 20. Data Rate Monitor
- 21. QSPI Programmer
- 22. UART Terminal
- 23. Terminal Scripting
- 24. RF Master
- 25. SUOTA (Software Update Over The Air)
- 26. Log
- 27. Working with multiple tools
- 28. Working with multiple settings
- 29. Command-line implementation
- 30. Appendix A - RF Master firmware
- 31. Appendix B - Battery Lifetime Estimator CLI sample input and parameters files
- 32. Troubleshooting
- 32.1. Error “2nd stage bootloader rejected (-105)” on Connect or Booter
- 32.2. Error message on not supporting ARMv8-M architecture
- 32.3. Warning on CLI interface running from windows: WARNING: Could not open/create prefs root node Software\JavaSoft\Prefs at root 0x80000002. Windows RegCreateKeyEx...
- 32.4. Firmware file in Hex format does not start running when downloading to the board
- 33. Revision history
- 34. Status definitions
- 35. Disclaimer